Ipv6 Bgp Neighbor Default-Originate - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

ipv6 bgp neighbor default-originate

ipv6 bgp neighbor default-originate
Enables or disables the BGP local speaker to advertise a default route to the peer.
ipv6 bgp neighbor ipv6_address [default-originate]
no ipv6 bgp neighbor ipv6_address [default-originate]
Syntax Definitions
ipv6_address
Defaults
This default-originate parameter is disabled by default.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to disable the BGP peer default origination.
•
When this command is enabled, the local BGP speaker advertises the default route to the peer. Such a
default route overrides any learned default (propagation) and outbound policy. The default route
does not need to exist on the local router.
•
If the peer is capable of exchanging IP as well as IPv6 prefixes, the default route for both IP and IPv6
is advertised.
Examples
-> ipv6 bgp neighbor 2001::1 default-originate
-> no ipv6 bgp neighbor 2001::1 default-originate
Release History
Release 7.1.1; command was introduced.
Related Commands
show ipv6 bgp neighbors
MIB Objects
alaBgpPeer6Table
alaBgpPeer6Addr
alaBgpPeer6DefaultOriginate
page 19-224
The 128-bit IPv6 address for the neighbor.
Displays the configured IPv6 BGP peers.
OmniSwitch CLI Reference Guide
BGP Commands
::/0
March 2011