Ipv6 Bgp Neighbor Conn-Retry-Interval - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

BGP Commands

ipv6 bgp neighbor conn-retry-interval

The interval, in seconds, between BGP retries to set up a connection with another peer through the
transport protocol. In the connect state, BGP tries to set up a connection with a remote peer. If the
connection fails, then the connection retry interval starts. Once this interval elapses, BGP retries
setting up the connection.
ipv6 bgp neighbor ipv6_address [conn-retry-interval num]
Syntax Definitions
ipv6_address
num
Defaults
parameter
num
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
The connection retry time interval starts when a connection to a peer is lost.
•
Using this command without the num variable resets the variable to its default value.
Examples
-> ipv6 bgp neighbor 2001::2 conn-retry-interval 60
Release History
Release 7.1.1; command was introduced.
Related Commands
show ipv6 bgp neighbors
MIB Objects
alaBgpPeer6Table
alaBgpPeer6Addr
alaBgpPeer6ConnRetryInterval
OmniSwitch CLI Reference Guide
A 128-bit IPv6 address for the BGP neighbor.
The time interval (in seconds) between retries. The valid range is
0–65535.
default
120
Displays the configured IPv6 BGP peers.
March 2011
ipv6 bgp neighbor conn-retry-interval
page 19-223