Figure 121: Sample Frame Relay Over Mpls Configuration - Juniper JUNOSE SOFTWARE FOR E SERIES 11.0.X - BGP AND MPLS CONFIGURATION GUIDE 2009-12-30 Configuration Manual

JUNOSe 11.0.x BGP and MPLS Configuration Guide
or
Related Topics
Frame Relay over MPLS Configuration Example
The script provided in this section is one way to configure Frame Relay services over
MPLS. Explanation notes are provided within the script. You must change the script
for your specific configuration.
The topology example shown in Figure 121 on page 538 further explains the
configuration script.
NOTE: The route interface command is used toward the end of the configuration
script. You can substitute the mpls-relay command, depending on the tunneling
method best for your environment.

Figure 121: Sample Frame Relay over MPLS Configuration

hostname "host 1"
exception protocol ftp anonymous null
!--------------------------------------------------------------------------
!Configure CT3 interfaces in slot 4 for Frame Relay.
!--------------------------------------------------------------------------
538
Frame Relay over MPLS Configuration Example
host1(config-mpls-l2-group)#no member interface fast 13/0.2
host1()#interface fast 13/0.2
host1(config-subif)#no mpls-relay
member interface
mpls l2transport load-balancing-group