<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface aux 0
[Sysname-ui-aux0] speed 9600
stopbits
Syntax
stopbits { 1 | 1.5 | 2 }
undo stopbits
View
AUX interface view
Default Level
2: System level
Parameters
1: Sets the stop bits to 1.
1.5: Sets the stop bits to 1.5.
2: Sets the stop bits to 2.
Description
Use the stopbits command to set the stop bits of the user interface.
Use the undo stopbits command to revert to the default stop bits.
By default, the stop bits is 1.
The S5120-SI series do not support communication with a terminal emulation program with
stopbits set to 1.5.
Changing the stop bits value of the switch to a value different from that of the terminal emulation
utility does not affect the communication between them.
Examples
# Set the stop bits to 2.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface aux 0
[Sysname-ui-aux0] stopbits 2
1-20