Stopbits - H3C S3100 Series Command Manual

This command takes effect on AUX user interfaces only.
The transmission speed setting on the terminal and that on the device user interface must be the
same for communication.
Examples
# Set the transmission speed of the user interface AUX 0 to 115,200 bps.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface aux 0
[Sysname-ui-aux0] speed 115200

stopbits

Syntax
stopbits { 1 | 1.5 | 2 }
undo stopbits
View
AUX user interface view
Parameters
1: Sets the stopbits to 1.
1.5: Sets the stopbits to 1.5.
2: Sets the stopbits to 2.
Description
Use the stopbits command to set the stopbits of the user interface.
Use the undo stopbits command to revert to the default stopbits.
Execute these two commands in AUX user interface view only.
By default, the stopbits is 1.
The S3100 series do not support communication with a terminal emulation program with stopbits
set to 1.5.
Changing the stop bits value of the switch to a value different from that of the terminal emulation
utility does not affect the communication between them.
1-22