Module Removal/Installation Procedures; Removing The Module - Viavi mA-3A01 Operation Manual

Chapter 4 Care and Maintenance

Module Removal/Installation Procedures

Module Removal/Installation Procedures

This section covers removing and installing the module. The procedures in this section are
intended for Qualified Service Personnel.
CAUTION
Modules are ESD sensitive and should only be installed, removed and/or serviced by
Qualified Service Personnel.
Mise en Garde
Les modules sont sensibles aux DES et ils doivent seulement être installés, enlevés ou
entretenus par du personnel de service qualifié.

Removing the Module

How to Remove Module
1 Power down the Chassis.
2 Fully loosen the captive screws on each side of the module.
3 Grasp the module Securing Latches and pull the Latches outwards and away from
the module to disconnect the module from the Backplane Connectors.
4 Pull until the Securing Latches are at a 90° angle with the front of the module. See
Figure 4-8 on page
5 Grasp the module and pull to remove the module from the Chassis.
If the module is being returned to the factory for service, refer to section
mA-3A01" on page 4-7
Page 4-4
4-6.
for important information.
mA-3A01 AXIe Mass Storage Module Operation Guide
"Shipping the
Rev. B0
April 2020