On-Vehicle Service; Precautions; Abs Hydraulic Unit Operation Check (Using Suzuki Scan Tool); Abs Hydraulic Unit Operation Check (Not Using Suzuki Scan Tool) - Suzuki GRAND VITARA XL-7 Owner's Manual

On-Vehicle Service

Precautions

When connector are connected to ABS hydraulic unit/control
module assembly, do not disconnect connectors of sensors and
turn ignition switch ON. Then DTC will be set in ABS control mod-
ule.
ABS Hydraulic Unit Operation Check (Using
SUZUKI Scan Tool)
1) Connect SUZUKI scan tool to data link connector (DLC) (1)
with ignition switch OFF.
Special tool
(A) : SUZUKI scan tool
2) Turn ignition switch to ON position and check actuator opera-
tion using "HYDRAULIC CONTROL TEST" under "miscella-
neous test" ("MISC. TEST") mode of SUZUKI scan tool.
ABS Hydraulic Unit Operation Check
(Not Using Suzuki Scan Tool)
1) Check that basic brake system other than ABS is in good
condition.
2) Check that battery voltage is 11V or higher.
3) With "ABS" warning lamp, check that no abnormality is
detected in ABS. Refer to "DIAGNOSTIC TROUBLE CODE
(DTC) CHECK" in this section.
4) Lift up vehicle.
5) Set transmission to neutral and release parking brake.
6) Turn each wheel gradually by hand to check if brake drag-
ging occurs. If it does, correct.
7) With diag. switch terminal (2) of diagnosis connector (1) con-
nected to ground by using service wire (4), turn ignition
switch to ON position and check that "ABS" warning lamp
indicates normal DTC (DTC 12) referring to "DIAGNOSTIC
TROUBLE CODE (DTC) TABLE" in this section.
8) Turn ignition switch to OFF position.
ANTILOCK BRAKE SYSTEM (ABS) 5E2-29