Toyota Tundra 2005 Service - Repair - Maintenance page 3431

AC-66
INSTALLATION
1. INSTALL COMPRESSOR
(a) Install the compressor with the cooler bracket with the 4 bolts and nut.
Torque: 25 N·m (250 kgf·cm, 18 in.·lbf)
(b) Connect the connector.
2. CONNECT DISCHARGE AND SUCTION HOSES
Connect both hoses with the 2 nuts.
Torque: 10 N·m (100 kgf·cm, 7 in.·lbf)
NOTICE:
Hoses should be connected immediately after the caps have been removed.
HINT:
Lubricate 2 new O-rings with compressor oil and install them to the hoses.
3. INSTALL AND CHECK DRIVE BELT (See page
4. CONNECT NEGATIVE (-) TERMINAL CABLE TO BATTERY
5. EVACUATE AIR FROM REFRIGERATION SYSTEM
6. CHARGE SYSTEM WITH REFRIGERANT
Specified amount:
Access cab, Standard cab: 600 ± 50 g (21.16 ± 1.76 oz.)
Double cab: 530 ± 50 g (18.69 ± 1.76 oz.)
7. INSPECT FOR LEAKAGE OF REFRIGERANT
Using a gas leak detector, check for leakage of refrigerant.
If there is leakage, check the tightening torque at the joints.
AIR CONDITIONING - COMPRESSOR AND MAGNETIC CLUTCH (2UZ-FE)
AC-19 and AC-17 )
Author : Date :
AC3SO-01
5093