Toyota Tundra 2005 Service - Repair - Maintenance page 3423

AC-58
AIR CONDITIONING - COMPRESSOR AND MAGNETIC CLUTCH (1GR-FE)
INSTALLATION
1. INSTALL COMPRESSOR AND MAGNET CLUTCH
(a) Install the compressor and the magnetic clutch with the 4
bolts.
Torque: 24 N m (245 kgf cm, 18 ft lbf)
(b) Connect the connector.
I28955
2. INSTALL SUCTION HOSE
(a) Remove the attached vinyl tape from the hose.
(b) Sufficiently apply compressor oil to a new O-ring and the
fitting surfaces of the compressor and magnetic clutch.
Compressor oil: ND-OIL 8 or equivalent
(c) Install the O-ring on the suction hose sub-assy.
(d) Install the suction hose sub-assy on the compressor and
magnetic clutch with the nut.
Torque: 10 N m (100 kgf cm, 7 in. lbf)
I28954
3. INSTALL DISCHARGE HOSE
(a) Remove the attached vinyl tape from the hose.
(b) Sufficiently apply compressor oil to a new O-ring and the
fitting surfaces of the compressor and magnetic clutch.
Compressor oil: ND-OIL 8 or equivalent
(c) Install the O-ring on the discharge hose sub-assy.
(d) Install the discharge hose sub-assy on the compressor
and magnetic clutch with the nut.
Torque: 10 N m (100 kgf cm, 7 in. lbf)
I28953
4. INSTALL AND CHECK DRIVE BELT
(See page
5. INSTALL ENGINE UNDER COVER
6. CONNECT NEGATIVE (-) TERMINAL CABLE TO BAT-
TERY
7. EVACUATE AIR FROM REFRIGERATION SYSTEM
8. CHARGE SYSTEM WITH REFRIGERANT
Specified amount:
Access cab, Standard cab:
600 ± 50 g (21.16 ± 1.76 oz.)
Double cab:
530 ± 50 g (18.69 ± 1.76 oz.)
9. INSPECT FOR LEAKAGE OF REFRIGERANT
Using a gas leak detector, check for leakage of refrigerant.
If there is leakage, check the tightening torque at the joints.
AC-19 and AC-17 )
Author :
AC3SI-01
Date :
5085