Toyota Tundra 2005 Service - Repair - Maintenance page 3397

AC-32
Disconnect the tube
by hand
Screwdriver
Tube
Connect
Gap
AIR CONDITIONING
NOTICE:
z
z
I06919
HINT:
At the time of installation, refer to the following:
Wrong
z
z
3.
4.
5.
I06878
6.
7.
8.
9.
(a)
(b)
I11125
- COOLING UNIT
Do not use tools like a screwdriver to remove the
tube.
Cap the openings immediately to keep moisture or
dirt out of the system.
Lubricate 2 new O-rings with compressor oil and install
them to the tubes.
After connection, check the claw of the piping clamp is se-
curely engaged.
REMOVE GLOVE COMPARTMENT PARTS
REMOVE LOWER NO. 2 FINISH PANEL
REMOVE LOWER CENTER COVER
REMOVE LOWER LH FINISH PANEL
REMOVE LOWER COVER (See page
REMOVE NO. 4 HEATER TO REGISTER DUCT
REMOVE COOLING UNIT
Disconnect the connectors.
Remove the 3 screws, bolt and the cooling unit.
Author :
BO-1 11)
Date :
5059