Toyota Celica 2005 Repair Manual page 1180

4 Check P/T squib LH.
P/T Squib LH
Airbag
→ ← Sensor
Assembly
ON
DLC3
CG
TC
H01018
AB0119
H10600 H01085
OK
From the results of the above inspection, the malfunctioning part can now be considered normal.
To make sure of this, use the simulation method to check. If the malfunctioning part can not be
detected by the simulation method, replace all SRS components including the wire harness.
2005 CELICA (RM1131U)
DIAGNOSTICS
PREPARATION:
(a)
(b)
(c)
(d)
CHECK:
(a)
(b)
DTC B0138/72
(c)
(d)
(e)
OK:
H10634
HINT:
Codes other than code B0138/72 may be output at this time, but
they are not relevant to this check.
NG
− SUPPLEMENTAL RESTRAINT SYSTEM
Turn the ignition switch to LOCK.
Disconnect the negative (−) terminal cable from the bat-
tery, and wait at least for 90 seconds.
Connect the seat belt pretensioner LH (P/T squib LH)
connector.
Connect the negative (−) terminal cable to the battery,
and wait at least for 2 seconds.
Turn the ignition switch to ON, and wait at least for 10 se-
conds.
Clear the DTC stored in memory (See page DI−884).
Turn the ignition switch to LOCK, and wait at least for 10
seconds.
Turn the ignition switch to ON, and wait at least for 10 se-
conds.
Check the DTC (See page DI−884).
DTC B0138/72 is not output.
Replace seat belt pretensioner LH
(P/T squib LH).
1179
DI−979