Toyota Celica 2005 Repair Manual page 1188

8 Check airbag sensor assembly.
Side Airbag Sensor
Assembly LH
→ ←
DLC3
TC
CG
H01012
AB0119 H01065
H10600 H01066
OK
From the results of the above inspection, the malfunctioning part can now be considered normal.
To make sure of this, use the simulation method to check.
2005 CELICA (RM1131U)
DIAGNOSTICS
Airbag
Sensor
Assembly
→ ←
ON
DTC B1140/32
DTC B1141/33
H21139
− SUPPLEMENTAL RESTRAINT SYSTEM
PREPARATION:
(a) Turn the ignition switch to LOCK.
(b) Disconnect the negative (−) terminal cable from the bat-
tery, and wait at least for 90 seconds.
(c) Connect the connector to airbag sensor assembly.
(d) Change the side airbag sensor assembly LH position with
RH position.
(e) Connect the negative (−) terminal cable to the battery,
and wait at least for 2 seconds.
CHECK:
(a) Turn the ignition switch to ON, and wait at least for 10 se-
conds.
(b) Clear the DTC stored in memory (See page DI−884).
(c) Turn the ignition switch to LOCK, and wait at least for 10
seconds.
(d) Turn the ignition switch to ON, and wait at least for 10 se-
conds.
(e) Check the DTC (See page DI−884).
OK:
Neither DTC B1140/32 nor B1141/33 are not output.
HINT:
Codes other than code B1140/32 or B1141/33 may be output
at this time, but they are not relevant to this check.
NG Replace airbag sensor assembly
(DTC B1140/32 is output).
NG Replace side airbag sensor assembly RH
(DTC B1141/33 is output).
1187
DI−987