Toyota Celica 2005 Repair Manual page 1194

8 Check airbag sensor assembly.
→ ←
→ ←
Side Airbag Sensor
Assembly RH
DLC3
CG
TC
H01007
AB0119 H01065
H10600 H01066
OK
From the results of the above inspection, the malfunctioning part can now be considered normal.
To make sure of this, use the simulation method to check.
2005 CELICA (RM1131U)
DIAGNOSTICS
PREPARATION:
(a)
(b)
Airbag
Sensor
(c)
Assembly
(d)
ON
(e)
CHECK:
DTC B1140/32
(a)
(b)
(c)
DTC B1141/33
(d)
(e)
OK:
H21140
HINT:
Codes other than code B1141/33 or B1141/32 may be output
at this time, but they are not relevant to this check.
− SUPPLEMENTAL RESTRAINT SYSTEM
Turn the ignition switch to LOCK.
Disconnect the negative (−) terminal cable from the bat-
tery, and wait at least for 90 seconds.
Connect the connector to the airbag sensor assembly.
Change the side airbag sensor assembly RH position with
LH position.
Connect the negative (−) terminal cable to the battery,
and wait at least for 2 seconds.
Turn the ignition switch to ON, and wait at least for 10 se-
conds.
Clear the DTC stored in memory (See page DI−884).
Turn the ignition switch to LOCK, and wait at least for 10
seconds.
Turn the ignition switch to ON, and wait at least for 10 se-
conds.
Check the DTC (See page DI−884).
Neither DTC B1141/33 nor B1140/32 are not output.
NG Replace airbag sensor assembly
(DTC B1141/33 is output).
NG Replace side airbag sensor assembly LH
(DTC B1140/32 is output).
1193
DI−993