Mac-Address-Table Static - Dell C9000 Series Reference Manual

Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version
9.10(0.0)
Usage Information If you use the mac-address-table disable-learning command without
specifying any option, the system does not learn source MAC addresses from LACP or
LLDP BPDUs.

mac-address-table static

Associate specific MAC or hardware addresses to an interface and VLANs.
C9000 Series
Syntax
mac-address-table static mac-address {multicast vlan vlan-id
output—range interface}{output interface vlan vlan-id}
To remove a MAC address, use the no mac-address-table static mac-address
output interface vlan vlan-id command.
Parameters
mac-address
multicast
output interface
Description
Introduced on the S3048–ON, S3100 series, S4048–ON, S4810,
S4820T, S5000, S6000, S6000–ON, Z9100–ON, and Z9500.
Enter the 48-bit hexadecimal address in nn:nn:nn:nn:nn:nn
format.
Enter a vlan port to where L2 multicast MAC traffic is forwarded.
NOTE: Use this option if you want multicast functionality
in an L2 VLAN without IGMP protocols.
For a unicast MAC address, enter the keyword output then one
of the following interfaces for which traffic is forwarded:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Layer 2 1311