Dell C9000 Series Reference Manual page 1706

host ip-address
destination
operator
Defaults none
Command Modes REDIRECT-LIST
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.8(0.0)
9.7(0.0)
9.7(0.0)
9.5(0.1)
9.4(0.0)
8.4.2.1
8.4.2.0
7.7.1.0
Enter the keyword host then the IP address to specify a host IP
address.
Enter the IP address of the network or host to which the packets
are sent.
(OPTIONAL) For TCP and UDP parameters only. Enter one of the
following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two
ports for theport command parameter.)
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048–ON.
Introduced on the S6000-ON.
Added support for the track-id on the S4810, S4820T, S6000,
and Z9000.
Introduced on the Z9500.
Introduced on the S4810, S4820T, S6000, and Z9000.
Introduced on the C-Series and S-Series.
Introduced on the E-Series TeraScale.
Introduced on the E-Series ExaScale.
Policy-based Routing (PBR) 1706