Stack Unit - Dell C9000 Series Reference Manual

Related
clear hardware system-flow
Commands
components.
show system
member.

stack unit

Pre-provision the specified port-extender stack unit.
C9000 Series
Syntax
stack-unit unit-number {type unit-type | priority value}
To de-provision or delete a port extender stack unit, use the no stack-unit unit-
number {type unit-type | priority value} command.
Parameters
stack-unit unit-
number
type PE-type
priority value
Default None
Command Modes PE CONFIG
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command-Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
Usage Information You can pre-provision a port extender stack unit using the stack unit command in
the PE configuration mode and specify the stack-unit type. Only similar types of stack
units are provisioned under a single port extender. The maximum number of stack units
allowed for provisioning is 8. In a PE stack, by default, the stack unit with the highest
MAC address is elected master; the stack unit with the second highest MAC address is
— clears the statistics from selected hardware
— displays the current status of all the stack members or a specific
Enter the stack-unit ID number to locate a specific stack unit.
Stack unit number range is 0–7.
Enter a value for the stack-unit type. The only support value for
stack-unit type is C1048P.
Enter the master priority value for the unit. The priority value
range is from 1 to 14. The unit with the numerically highest
priority value is elected the master.
Description
Introduced on the C9010.
PE Stacking 1637