Location-Led - Dell C9000 Series Reference Manual

VRF
Extended-Bridge
Related pe provision
Commands

location-led

Toggle the location LED of a specified interface, linecard or port extender (PE) on or off.
C9000 Series
Syntax
location—led {interface interface | linecard slot-id | pe pe-id
stack-unit unit-number | rpm slot-id }{off|on}
Parameters
interface interface
linecard slot-id
pe pe-id
stack-unit unit
number
rpm slot-id
on |off
Default
None
Command Modes
EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
disabled
enabled
— Logically provision or add a PE.
Enter the following keywords and slot/port or number
information:
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
gigabitethernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
Enter the keyword linecard and the slot ID. The linecard slot-
id range is from 0 to 9.
Enter the keyword pe and the PE ID. The range is from 0 to 255.
Enter the keyword stack-unit and the stack unit number. The
range is from 0 to 7.
Enter the keyword rpm and specify the route processor slot ID.
RPM slot-id values are rpm0 and rpm1 .
Turn the location LED(s) of the specified interfaces, linecard,
port extenders (PE), ports and RPMs on or off.
Port Extenders (PE) 1717