Defaults
none
Command Modes
CLASS-MAP CONFIGURATION (config-class-map)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.11.1
8.3.7.0
7.7.1.0
7.6.1.0
7.5.1.0
7.5.1.0
6.1.1.1
Usage Information To access this command, enter the class-map command. After the class map is
identified, you can configure the match criteria. For class-map match-any, a maximum
of five ACL match criteria are allowed. For class-map match-all, only one ACL
match criteria is allowed.
Related
class-map
Commands
match ip dscp
Use a differentiated services code point (DSCP) value as a match criteria.
C9000 Series
Syntax
match {ip | ipv6 | ip-any} dscp dscp-list [set-ip-dscp value |
set-color value]
To remove a DSCP value as a match criteria, use the no match {ip | ipv6 | ip-
any} dscp dscp-list [[multicast] set-ip-dscp value | set-color
value] command.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the Z9000.
Introduced on the S4810.
Added the DSCP Marking option support on the S-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Added support for the DSCP Marking option.
Introduced on the E-Series.
— identifies the class map.
Quality of Service (QoS)
1805