Dell C9000 Series Reference Manual page 1008

To return to the default setting, use the no speed {10 | 100 | 1000 | 10000}
command.
Parameters
10
100
1000
10000
auto
Defaults auto
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(0.0P5)
9.8(0.0P2)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
Enter the keyword 10 to set the interface's speed to 10 Mb/s.
NOTE: This interface speed is not supported on the LC-
EH-GE-50P or the LC-EJ-GE-50P card. If the command
is entered for these interfaces, an error message appears.
Enter the keyword 100 to set the interface's speed to 10/100
Mb/s.
NOTE: When this setting is enabled, only 100Base-FX
optics are supported on the LC-EH-GE-50P or the LC-
EJ-GE-50P card.
Enter the keyword 1000 to set the interface's speed to 1000
Mb/s. Auto-negotiation is enabled. For more information, refer
to negotiation auto.
NOTE: When this setting is enabled, only 1000Base-FX
optics are supported on the LC-EH-GE-50P or the LC-
EJ-GE-50P card.
Enter the keyword 10000 to set the interface's speed to 10000
Mb/s. Auto-negotiation is enabled. For more information, refer
to negotiation auto.
Enter the keyword auto to set the interface to auto-negotiate
its speed. Auto-negotiation is enabled. For more information,
refer to negotiation auto.
Description
Added support for fanned–out 1 Gigabit SFP port.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Interfaces 1008