Ipv6 Address Eui64 - Dell C9000 Series Reference Manual

ipv6 address eui64

Configure IPv6 EUI64 address configuration on the interface.
C9000 Series
Syntax
ipv6 address {ipv6-address prefix-length} eui64
To disable IPv6 EUI64 address autoconfiguration, use the no ipv6 address {ipv6-
address prefix-length} eui64 command.
Parameters
ipv6-address
prefix-length
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
9.2(0.0)
• Removing auto-configuration removes all auto-configured IPv6 addresses and
the link-local IPv6 address from that management interface.
• IPv6 addresses on a single management interface cannot be members of the
same subnet.
• IPv6 secondary addresses on management interfaces across a platform must be
members of the same subnet.
• IPv6 secondary addresses on management interfaces should not match the virtual
IP address and should not be in the same subnet as the virtual IP.
Enter the IPv6 prefix in the x:x:x:x::x format then the prefix
length in the /x format. The range is from /0 to /128.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
IPv6 Basics 1272