Dell C9000 Series Reference Manual page 1360

To remove advertised dot1-tlv, use the no advertise dot1-tlv {port-
protocol-vlan-id | port-vlan-id | vlan-name} command.
Parameters
port-protocol-
vlan-id
port-vlan-id
vlan-name
Defaults Disabled.
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.7.1.0
7.6.1.0
7.4.1.0
Related
protocol lldp (Configuration)
Commands
debug lldp interface
show lldp neighbors
show running-config lldp
Enter the keywords port-protocol-vlan-id to advertise the
port protocol VLAN identification TLV.
Enter the keywords port-vlan-id to advertise the port VLAN
identification TLV.
Enter the keywords vlan-name to advertise the vlan-name TLV.
This keyword is only supported on the C-Series and S-Series.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series. Added the vlan-name option.
Introduced on the C-Series.
Introduced on the E-Series.
— enables LLDP globally.
— debugs LLDP.
— displays the LLDP neighbors.
— displays the LLDP running configuration.
Link Layer Discovery Protocol (LLDP) 1360