Dell C9000 Series Reference Manual page 1697

Networking command-line reference guide

Hide thumbs Also See for C9000 Series:

Table of Contents

Command History

This guide is platform-specific. For command information about other platforms, see

the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Usage Information The following describes the show ip pim tib command shown in the following

Introduced on the C9010.

Introduced on the Z9500.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the Z9000.

Introduced on the E-Series ExaScale.

Introduced on the S-Series.

Displays the entry in the multicast PIM database.

Displays the amount of time the entry has been in the PIM route

Displays the amount of time until the entry expires and is

removed from the database.

Displays the IP address of the RP/source for this entry.

List the flags to define the entries:

D = PIM Dense Mode

S = PIM Sparse Mode

C = directly connected

L = local to the multicast group

P = route was pruned

R = the forwarding entry is pointing toward the RP

F = Dell Networking OS is registering this entry for a

multicast source

T = packets were received via Shortest Tree Path

J = first packet from the last hop router is received and the

entry is ready to switch to SPT

K = acknowledge pending state

Displays the reverse path forwarding (RPF) interface towards the

PIM-Sparse Mode (PIM-SM)

Chapters

Table of Contents