Management-Interface; Mode - Dell C9000 Series Reference Manual

management-interface

Enable and configure LLDP protocol parameters on the management interface.
C9000 Series
Syntax
management-interface
To remove LLDP configuration on a management interface, use the no management-
interface command.
Command Modes LLDP (conf-lldp)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
9.2(0.0)
Usage Information To enable LLDP on the management interface, use the no disable command in
LLDP-MANAGEMENT-INTERFACE mode (conf-lldp-mgmtIf).

mode

To receive or transmit, set LLDP.
C9000 Series
Syntax
mode {tx | rx}
To return to the default, use the no mode {tx | rx} command.
Parameters
tx
rx
Defaults Both transmit and receive.
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the Z9000 and S4810.
Enter the keyword tx to set the mode to transmit.
Enter the keyword rx to set the mode to receive.
Link Layer Discovery Protocol (LLDP) 1370