Ip Pim Ingress-Interface-Map - Dell C9000 Series Reference Manual

Version
9.9(0.0)
9.8(0.0)
9.7(0.0)
9.5(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.8.1.0
7.7.1.0
Example
Dell(conf)# ip access-list extended iptv-channels
Dell(config-ext-nacl)# permit ip 10.1.2.3/24 225.1.1.0/24
Dell(config-ext-nacl)# permit ip any 232.1.1.0/24
Dell(config-ext-nacl)# permit ip 100.1.1.0/16 any
Related ip access-list extended
Commands

ip pim ingress-interface-map

When the Dell Networking system is the RP, statically map potential incoming interfaces to (*,G) entries to
create a lossless multicast forwarding environment.
C9000 Series
Syntax
ip pim ingress-interface-map std-access-list
Parameters
std-access-list
Defaults none
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
Removed the in and out parameters. Introduced on the S6000-
ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series for the port-channels and the S-
Series.
Introduced on the E-Series.
— configure an access list based on IP addresses or protocols.
Enter the name of a standard access list.
PIM-Sparse Mode (PIM-SM) 1678