Hello - Dell C9000 Series Reference Manual

debug lldp interface
show lldp neighbors
show running-config lldp

hello

Configure the rate at which the LLDP control packets are sent to its peer.
C9000 Series
Syntax
hello seconds
To revert to the default, use the no hello seconds command.
Parameters
seconds
Defaults 30 seconds
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.7.1.0
7.6.1.0
7.4.1.0
— debugs LLDP.
— displays the LLDP neighbors.
— displays the LLDP running configuration.
Enter the rate, in seconds, at which the control packets are sent
to its peer. The rate is from 5 to 180 seconds. The default is 30
seconds.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Link Layer Discovery Protocol (LLDP) 1369