Dell C9000 Series Reference Manual page 1291

tunnel tunnel-id
vlan
Defaults none
Command Modes
•
•
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.5(0.1)
9.2(1.0)
9.2.(0.0)
9.0.0.0
8.3.19.0
8.3.7.0
8.5.1.0
8.4.2.1
8.2.1.0
7.8.1.0
7.4.1.0
Usage Information The Management port is enabled by default (no shutdown). If necessary, use the ipv6
address command to assign an IPv6 address to the Management port.
Example
Dell# show ipv6 interface linecard 0
TenGigabitEthernet 0/2 is down, line protocol is down
(OPTIONAL) View information for a tunnel interface.
(OPTIONAL) View information for IPv6 VLANs.
EXEC
EXEC Privilege
Description
Introduced on the C9010.
Added support for IPv6 recursive DNS addresses.
Introduced on the Z9500.
Added support for tunnel interface.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S-Series.
Introduced on the E-Series ExaScale. Added support for the
managementethernet slot/port parameter.
Introduced on the C-Series.
Introduced on the E-Series TeraScale.
IPV6 is enabled
Link Local address: fe80::7686:7aff:feff:6f08
Global Unicast address(es):
10:10:10:1::8, subnet is 10:10:10::/48 (MANUAL)
Remaining lifetime: infinite
Global Anycast address(es):
Joined Group address(es):
ff02::1
ff02::2
ff02::1:ff00:8
ff02::1:ffff:6f08
ND MTU is 0
ICMP redirects are not sent
IPv6 Basics 1291