Discard - Dell C9000 Series Reference Manual

Version
9.10(0.0)
Usage Information The Configuration Terminal Batch mode is used to setup common configurations on a
port extender connected in a dual-homing environment. Use the commit command to
apply the configuration changes. In the Configuration Terminal Batch mode, you can
continue to commit the changes without exiting the batch mode.
Example Example with multiple Commits:
Dell#configure terminal batch
Peer is registered
Dell(conf-b)#interface peGigE 184/0/1
Dell(conf-b-if-pegi-184/0/1)#no shutdown
Dell(conf-b-if-pegi-184/0/1)#commit
Dell(conf-b)#Apr 5 06:48:28: %RPM1-P:CP %CLIBATCH-6-
CLI_BATCH_CONFIG_IN_PROGRESS_TRAP: Batch configuration commit is
in progress
Apr 5 06:48:28: %RPM1-P:CP %IFMGR-5-ASTATE_UP: Changed interface
Admin state to up: PeGi 184/0/1
Apr 5 06:48:28: %RPM1-P:CP %CLIBATCH-6-
CLI_BATCH_CONFIG_COMPLETE_TRAP: Batch configuration commit is
success
Dell(conf-b)#interface peGigE 184/0/1
Dell(conf-b-if-pegi-184/0/1)#switchport
Dell(conf-b-if-pegi-184/0/1)#int vla 1000
Dell(conf-b-if-vl-1000)#tagged peGigE 184/0/1
Dell(conf-b-if-vl-1000)#commit
Dell(conf-b)#Apr 5 06:48:47: %RPM1-P:CP %CLIBATCH-6-
CLI_BATCH_CONFIG_IN_PROGRESS_TRAP: Batch configuration commit is
in progress
Apr 5 06:48:47: %RPM1-P:CP %IFMGR-5-ACTIVE: Changed Vlan
interface state to active: Vl 1000
Apr 5 06:48:48: %RPM1-P:CP %CLIBATCH-6-
CLI_BATCH_CONFIG_COMPLETE_TRAP: Batch configuration commit is
success

discard

Use the discard command to cancel the uncommitted changes made to common configurations in the
Configuration Terminal Batch mode.
C9000 Series
Syntax
discard
Default None
Command Modes CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
Description
Introduced on the C9010.
Port Extenders (PE) 1729