Fip-Snooping Fc-Map - Dell C9000 Series Reference Manual

To disable the FIP snooping feature on all or a specified VLAN, use the no fip-
snooping enable command.
Defaults FIP snooping is disabled on all VLANs.
Command Modes
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
8.3.19.0
8.3.12.0
Usage Information The maximum number of FCFs supported per FIP snooping-enabled VLAN is twelve.
The maximum number of FIP snooping sessions supported per ENode server is 32 by
default. You can configure up to 64 sessions.

fip-snooping fc-map

Configure the FC-MAP value FIP snooping uses on all VLANs.
C9000 Series
Syntax
fip-snooping fc-map fc-map-value
To return the configured FM-MAP value to the default value, use the no fip-
snooping fc-map command.
Parameters
fc-map-value
Defaults 0x0EFC00
Command Modes
• CONFIGURATION
• VLAN INTERFACE
Description
Introduced on the C9010.
Introduced on the S4820T.
Introduced on the S4810.
Enter the FC-MAP value FIP snooping uses. The range is from
0EFC00 to 0EFCFF.
• CONFIGURATION
• VLAN INTERFACE
FCoE Transit 857