Dell C9000 Series Reference Manual page 1221

Version
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Usage Information The following describes the show ip interface command shown in the following
example.
Lines
TenGigabitEthern
et 0/0...
Internet address...
IP MTU is...
Inbound access...
Proxy ARP...
Split horizon...
Poison Reverse...
ICMP redirects...
ICMP
unreachables...
Example
Dell# show ip interface tengigabitethernet 2
TenGigabitEthernet 2/0 is down, line protocol is down
Internet address is not set
IP MTU is 1500 bytes
Directed broadcast forwarding is disabled
Proxy ARP is enabled
Split Horizon is enabled
Poison Reverse is disabled
ICMP redirects are not sent
ICMP unreachables are not sent
TenGigabitEthernet 2/1 is down, line protocol is down
Internet address is not set
IP MTU is 1500 bytes
Directed broadcast forwarding is disabled
Proxy ARP is enabled
Split Horizon is enabled
Poison Reverse is disabled
ICMP redirects are not sent
ICMP unreachables are not sent
TenGigabitEthernet 2/2 is down, line protocol is down
Internet address is not set
IP MTU is 1500 bytes
Description
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Displays the interface's type, slot/port, and physical and line
protocol status.
States whether an IP address is assigned to the interface. If an IP
address is assigned, that address is displayed.
Displays IP MTU value.
Displays the name of the configured incoming access list. If
none is configured, the phrase "not set" is displayed.
States whether proxy ARP is enabled on the interface.
States whether split horizon for RIP is enabled on the interface.
States whether poison for RIP is enabled on the interface.
States if ICMP redirects are sent.
States if ICMP unreachable messages are sent.
IPv4 Routing 1221