Channel-Member - Dell C9000 Series Reference Manual

channel-member

Add an interface to the Port Channel, while in INTERFACE PORTCHANNEL mode.
C9000 Series
Syntax
channel-member interface
To delete an interface from a Port Channel, use the no channel-member interface
command.
Parameters
interface
Defaults Not configured.
Command Modes INTERFACE PORTCHANNEL
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.5.1.0
8.3.7.0
8.1.1.0
(OPTIONAL) Enter any of the following keywords and slot/port,
peid/stack-unit/port-id, or number information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a port extender Gigabit Ethernet interface, enter the
keyword peGigE then the pe-id / stack-unit / port-id
information. The pe-id range is from 0 to 255; the stack-
unit unit-number range is from 0 to 7; and the port-id
range is from 1 to 48.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Interfaces 1018