Speed (Management Interface) - Dell C9000 Series Reference Manual

Networking command-line reference guide

Hide thumbs Also See for C9000 Series:

Table of Contents

E-Series legacy

Usage Information This command is found on the 10/100/1000/10000 Base-T Ethernet interfaces.

When you enable auto, the system performs an automatic discovery to determine the

optics installed and configure the appropriate speed.

When you configure a speed for the 10/100/1000/10000 interface, confirm the

negotiation auto command setting. Both sides of the link must have auto-negotiation

either enabled or disabled. For speed settings of 1000 or auto, the software sets the link

to auto-negotiation and you cannot change that setting.

If you use an active optical cable (AOC), you can convert the QSFP+ port to a 10

Gigabit SFP+ port or 1 Gigabit SFP port. You can use the speed command to enable

the required speed.

speed (Management interface)

Set the speed for the Management interface.

C9000 Series

speed {10 | 100 | auto}

To return to the default setting, use the no speed {10 | 100} command.

Supported on LC-EH-GE-50P or the LC-EJ-GE-50P cards.

Introduced on the E-Series.

Introduced on the S-Series.

Introduced on the C-Series.

Starting with Dell Networking OS version 7.8.1.0, when you use a copper

SFP2 module with catalog number GP-SFP2-1T in the S25P model of the S-

Series, you can manually set its speed with the speed command. When you set

the speed to 10 or 100 Mbps, you can also use the duplex command.

Enter the keyword 10 to set the interface's speed to 10 Mb/s.

Enter the keyword 100 to set the interface's speed to 10/100

Enter the keyword auto to set the interface to auto-negotiate

Table of Contents