Ip Pim Neighbor-Filter - Dell C9000 Series Reference Manual

Version
9.9(0.0)
9.5(0.1)
8.3.19.0
8.3.12.0
8.4.1.0
Example
Dell(conf)# ip access-list standard map1
Dell(config-std-nacl)# permit 224.0.0.1/24
Dell(config-std-nacl)#exit
Dell(conf)#int tengig 1/1
Dell(config-if-te-1/1)# ip pim ingress-interface-map map1

ip pim neighbor-filter

To prevent a router from participating in protocol independent multicast (PIM), configure this feature.
C9000 Series
Syntax
ip pim neighbor-filter {access-list}
To remove the restriction, use the no ip pim neighbor-filter {access-list}
command.
Parameters
access-list
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.5(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced
Enter the name of a standard access list. Maximum 16
characters.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
PIM-Sparse Mode (PIM-SM) 1679