Dell C9000 Series Reference Manual page 1410

Networking command-line reference guide

Hide thumbs Also See for C9000 Series:

Table of Contents

To remove the originator-id, use the no ip msdp originator-id {interface}

Not configured.

Command Modes

CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, refer

to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Enter the following keywords and slot/port or number

information:

For a Loopback interface, enter the keyword loopback

then a number from 0 to 16383.

For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 4096.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a VLAN, enter the keyword vlan then a number from 1

Introduced on the C9010.

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Added support for 4-port 40G line cards on ExaScale.

Multicast Source Discovery Protocol (MSDP)

Chapters

Table of Contents