Dell C9000 Series Reference Manual page 1324

Column
Heading
Type
Interface
State
Example
Dell(conf)#do show mac-address-table
Codes: *N - VLT Peer Synced MAC
VlanId
2
2
2
100
2
10
Usage Information The following describes the show mac-address-table command shown in the
following example.
Column
Heading
VlanId
Mac Address
Type
Interface
State
The following describes the show mac-address-table count command shown in
the following example.
Description
Lists whether the MAC address was manually configured (Static),
learned dynamically (Dynamic), or associated with a specific port
(Sticky).
Displays the interface type and slot/port information. The
following abbreviations describe the interface types:
• po — Port Channel then a number. The range is from 1 to
255 for TeraScale.
• te — 10-Gigabit Ethernet then a slot/port.
• fo — 40-Gigabit Ethernet then a slot/port.
Lists if the MAC address is in use (Active) or not in use (Inactive).
Mac Address
00:00:00:00:00:01
00:00:00:00:00:02
00:00:00:00:00:03
Active
00:00:00:00:00:04
Active
Description
Displays the VLAN ID number.
Displays the MAC address in nn:nn:nn:nn:nn:nn format.
Lists whether the MAC address was manually configured (Static),
learned (Dynamic), or associated with a specific port (Sticky). An
(N) indicates that the specified MAC address has been learnt by a
neighbor and is synced to the node.
Displays the interface type and slot/port information. The
following abbreviations describe the interface types:
• po — Port Channel followed by a number. Range for
Terascale is from 1 to 255. \
• te — 10–Gigabit Ethernet followed by a slot/port.
• fo — 40-Gigabit Ethernet then a slot/port.
Lists if the MAC address is in use (Active) or not in use (Inactive).
Type Interface
Dynamic (N) Po 128
Dynamic (N) Po 10
Dynamic
Dynamic
State
Active
Active
Po
Po
Layer 2 1324