Maximum-Paths - Dell C9000 Series Reference Manual

Version
8.3.11.1
Usage Information Change the maximum LSP lifetime with this command. The maximum LSP lifetime
must always be greater than the LSP refresh interval.
The seconds parameter enables the router to keep LSPs for the specified length of
time. If the value is higher, the overhead is reduced on slower-speed links.
Related lsp-refresh-interval
Commands

maximum-paths

Configure the maximum number of equal cost paths allowed in a routing table.
C9000 Series
NOTE: You can use the maximum-paths command to configure a single system wide value that is
common for both IPv4 and IPv6 addresses.
Syntax
maximum-paths number
To return to the default values, use the no maximum-paths command.
Parameters
number
Defaults 4
Command Modes
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.8(0.0)
Description
Introduced on the Z9000.
— sets the link-state packet (LSP) refresh interval.
Enter a number as the maximum number of parallel paths an IP
routing installs in a routing table. The range is from 1 to 64. The
default is 4.
• ROUTER ISIS (for IPv4)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
Intermediate System to Intermediate System (IS-IS) 1093