Redistribute - Dell C9000 Series Reference Manual

The default keyword sets all interfaces as passive. You can then configure individual
interfaces, where adjacencies are desired, using the no passive-interface
interface command. The no form of this command is inserted into the configuration
for individual interfaces when the no passive-interface interface command is
issued while passive-interface default is configured.
This command behavior has changed as follows:
passive-interface interface
passive-interface default
no passive-interface interface
No passive-interface default

redistribute

Redistribute information from another routing protocol throughout the OSPF process.
C9000 Series
Syntax
redistribute {connected | rip | static} [metric metric-value |
metric-type type-value] [route-map map-name] [tag tag-value]
To disable redistribution, use the no redistribute {connected | isis | rip |
static} command.
• The previous no passive-interface interface is removed from the running
configuration.
• The ABR status for the router is updated.
• Save passive-interface interface into the running configuration.
• All present and future OSPF interfaces are marked as passive.
• Any adjacency is explicitly terminated from all OSPF interfaces.
• All previous passive-interface interface commands are removed from the
running configuration.
• All previous no passive-interface interface commands are removed from
the running configuration.
• Remove the interface from the passive list.
• The ABR status for the router is updated.
• If passive-interface default is specified, then save no passive-
interface interface into the running configuration.
• Clear everything and revert to the default behavior.
• All previously marked passive interfaces are removed.
• May update ABR status.
Open Shortest Path First (OSPFv2 and OSPFv3) 1519