Dell C9000 Series Reference Manual page 1338

Networking command-line reference guide

Hide thumbs Also See for C9000 Series:

Table of Contents

To remove an untagged interface from a VLAN, use the no untagged interface

All interfaces in Layer 2 mode are untagged.

Command Modes

INTERFACE VLAN

Command History

This guide is platform-specific. For command information about other platforms, see

the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Usage Information Untagged interfaces can only belong to one VLAN.

Enter the following keywords and slot/port or number

information:

For a Gigabit Ethernet interface, enter the keyword

GigabitEthernet then the slot/port information.

For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 128.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a port extender Gigabit Ethernet interface, enter the

keyword peGigE then the pe-id / stack-unit / port-id

information. The pe-id range is from 0 to 255; the stack-

unit unit-number range is from 0 to 7; and the port-id

range is from 1 to 48.

Introduced on the C9010.

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Added support for 4-port 40G line cards on ExaScale.

Introduced on the S4810.

Introduced on the S-Series.

Introduced on the C-Series.

Introduced on the E-Series.

Chapters

Table of Contents