Clear Pe Statistics - Dell C9000 Series Reference Manual

Usage Information This command provisions the port extender for automatic link aggregation group (LAG)
port channel creation on the connected ports. The LAG member ports must be
operationally up and have a default port configuration with no Layer 2 and Layer 3
configuration. The port interfaces must be of the same type. You can configure up to
16 switch ports in the auto-LAG.
Use cascade interface interface slot/port-range peer in the
Configuration Terminal Batch Mode to provision the port extender in a dual-homing
setup. It is recommended to configure the port extender through batch mode only in a
dual-homing setup. If the peer is not connected during the configuration, ensure that
you import the configuration from the peer once it is up. See
Example
PE Configuration Mode
Dell(conf)# feature extended-bridge
Dell(conf)# pe provision 4
Dell(conf-pe-4)#cascade interface tengigabitethernet 1/1-2
Configuration Terminal Batch Mode
Dell#conf terminal batch
Peer is registered
Dell(conf-b)#pe provision 4
Dell(conf-b-pe-4)#cascade interface tengigabitethernet 1/1-2

clear pe statistics

Delete the statistics related to a specified port extender.
C9000 Series
Syntax
clear pe pe-id statistics
Parameters
pe-id
statistics
Default
None
• The slot/port-range specifies a line card and either a single port number, a port
range, or a combination of both for auto-LAG configuration. The range of slot
numbers is from 0 to 9 for linecard slots. The range of port numbers is from 0 to
23.
Enter the keyword pe and the port extender ID. Range is from 0
to 255.
Enter the keyword statistics to delete the statistics related to
a specified PE from the system.
import peer-config.
Port Extenders (PE) 1714