Flex Hash And Optimized Boot-Up; Encapsulation Dot1Q - Dell C9000 Series Reference Manual

Networking command-line reference guide

Hide thumbs Also See for C9000 Series:

Table of Contents

Flex Hash and Optimized Boot-Up

This chapter describes the Flex Hash and fast-boot enhancements.

lacp fast-switchover

load-balance flexhash

load-balance ingress-port enable

encapsulation dot1q

Configures lite-subinterfaces. This command is supported on the S6000 platform.

encapsulation dot1q vlan-id

To remove a previously configured lite-subinterface, use the no version of this

dot1q vlan-id

Command Modes

Command History

Usage Information To enable routing of RRoCE packets, the VLAN ID is mapped to the default VLAN ID of

4095 and this mapping is performed using VLAN translation. After VLAN translation, the

RRoCE packets are considered in the same manner as normal IP packets that are

received on Layer 3 interface and routed in the egress direction. At the egress interface,

the VLAN ID is appended to the packet and transmitted out of the interface as a tagged

packet with the dot1Q value preserved. The dot1Q value is preserved only for egress

interfaces that are associated with a VLAN or a lite-subinterface . If a Layer 3 interface is

Enter the keyword dot1q followed by the VLAN ID to which the

host belongs. The range is from 1 to 4094. A lite subinterface is

considered as a Layer 3 port property and is synchronous with

the existing rules of applying Layer 2 or Layer 3 properties to an

Introduced on the C9010.

Introduced on the S6000 platform.

Flex Hash and Optimized Boot-Up

Table of Contents