Ip Igmp Ssm-Map - Dell C9000 Series Reference Manual

Version
9.10(0.0)
9.9(0.0)
9.5(0.1)
9.2(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
7.6.1.0
7.5.1.0

ip igmp ssm-map

To translate (*,G) memberships to (S,G) memberships, use a statically configured list.
C9000 Series
Syntax
ip igmp ssm-map std-access-list source-address
Undo this configuration, that is, remove SSM map (S,G) states and replace them with
(*,G) state, use the ip igmp ssm-map std-access-list source-address
command.
Parameters
std-access-list
source-address
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the S-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
Introduced on the C-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
Specify the standard IP access list that contains the mapping
rules for multicast groups.
Specify the multicast source address to which the groups are
mapped.
Internet Group Management Protocol (IGMP) 1134