Show Ip Pim Bsr-Router - Dell C9000 Series Reference Manual

Version
9.7(0.0)
9.5(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.8.1.0
7.7.1.1
Usage Information This command configures an expiration timer for all S.G entries, unless they are
assigned to an Extended ACL.
Even though the FHR nodes act as RPs, these nodes still send Register encap messages
to themselves and expect to receive a Register stop message (for Anycast RP support).
As a result, if the DLT timer expires, SG is not deleted until the register state is deleted in
the node. This register state expires 210 seconds after the last Null register is received.

show ip pim bsr-router

View information on the Bootstrap router.
C9000 Series
Syntax
show ip pim bsr-router
Command Modes
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.8(0.0)
9.7(0.0)
Description
Introduced on the S6000-ON and added support for VRF.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series for the port-channels and the S-
Series.
Introduced
• EXEC
• EXEC Privilege
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
Added support for VRF. Introduced on the S6000-ON.
PIM-Sparse Mode (PIM-SM) 1687