Dell C9000 Series Reference Manual page 1208

Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.7(0.1)
9.7(0.1)
9.7(0.0)
9.2(1.0)
9.0.2.0
9.0.0.0
8.3.19.0
8.3.11.1
8.1.1.0
7.5.1.0
pre-6.1.1.0
Usage Information When a static route (or a protocol route) overlaps with Management static route, the
static route (or a protocol route) is preferred over the Management Static route. Also,
Management static routes and the Management Connected prefix are not reflected in
the hardware routing tables. Separate routing tables are maintained for IPv4 and IPv6
management routes. This command manages both tables.
Related
interface ManagementEthernet
Commands
(either the Primary or Standby RPM).
speed (Management interface)
Description
Introduced on the C9010.
Introduced on the S3048-ON.
Introduced on the S4048-ON.
Added support for forty gigabit, vlan, and tengigabit ethernet
interfaces. Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the Z9000 and added support for IPv6.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Introduced on the E-Series.
— configures the Management port on the system
— sets the speed for the Management interface.
IPv4 Routing 1208