Show Config - Dell C9000 Series Reference Manual

The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
Usage Information Before you provision a port extender, enable the extended bridge feature using the
feature extended—bridge command. The pe provision pe-id command
logically pre-provisions or adds a port extender (PE) even when the PE is not physically
connected to the switch. The port extender ID (pe-id) range is from 0 to 255.
After provisioning a PE using the pe provision pe-id , you can provision a stack
unit using the stack-unit command.
You can provision a port extender connected in a Dual-Homing setup from the
Configuration Terminal Batch mode.
To de-provision a port extender, use the no pe provision pe-id command.
Example
DELL(conf)# pe provision 10
DELL(conf-pe-10)#
DELL(conf)# no pe provision 10
Related
Commands

show config

Display the PE provision configuration details.
C9000 Series
Syntax
show config
Command Modes PE CONFIG (conf-pe-pe-id)
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
NOTE: You must ensure that the port extender units are offline before you issue
the no pe provision command.
• feature extended-bridge
• stack unit
• show pe
Port Extenders (PE) 1720