Ip Host - Dell C9000 Series Reference Manual

Version
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.3.1.0
Usage Information This command disables the hop field increments when boot requests are relayed to a
DHCP server through the system. If the incoming boot request already has a non-zero
hops field, the message is relayed with the same value for hops. However, the message
is discarded if the hops field exceeds 16, to comply with the relay agent behavior
specified in RFC 1542.
Related
Commands

ip host

Assign a name and IP address for the host-to-IP address mapping table.
C9000 Series
Syntax
ip host name ip-address
To remove an IP host, use the no ip host name [ip-address] command.
Parameters
name
ip address
Defaults Not configured.
Command Modes CONFIGURATION
Description
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced for the E-Series.
• ip helper-address — specifies the destination broadcast or host address for DHCP
server requests.
• show running-config
default values.
Enter a text string to associate with one IP address.
Enter an IP address, in dotted decimal format, to be mapped to
the name.
— displays the current configuration and changes from the
IPv4 Routing 1193