Dell C9000 Series Reference Manual page 1367

Parameters
interface
all
events
packet
brief
detail
tx
rx
both
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
Enter the following keywords and slot/port or number
information:
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a Management Ethernet interface, enter the keyword
managementethernet then the slot/port information..
• For a port extender Gigabit Ethernet interface, enter the
keyword peGigE then the pe-id / stack-unit / port-id
information. The pe-id range is from 0 to 255; the stack-
unit unit-number range is from 0 to 7; and the port-id
range is from 1 to 48.
• For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet then the slot/port information.
(OPTIONAL) Enter the keyword all to display information on all
interfaces.
(OPTIONAL) Enter the keyword events to display major events
such as timer events.
(OPTIONAL) Enter the keyword packet to display information
regarding packets coming in or going out.
(OPTIONAL) Enter the keyword brief to display brief packet
information.
(OPTIONAL) Enter the keyword detail to display detailed
packet information.
(OPTIONAL) Enter the keyword tx to display transmit-only
packet information.
(OPTIONAL) Enter the keyword rx to display receive-only
packet information.
(OPTIONAL) Enter the keyword both to display both receive and
transmit packet information.
Description
Introduced on the C9010.
Introduced on the Z9500.
Link Layer Discovery Protocol (LLDP) 1367