Ip Igmp Query-Interval - Dell C9000 Series Reference Manual

Version
7.6.1.0
7.5.1.0

ip igmp query-interval

Change the transmission frequency of IGMP general queries the Querier sends.
C9000 Series
Syntax
ip igmp query-interval seconds
To return to the default values, use the no ip igmp query-interval command.
Parameters
seconds
Defaults 60 seconds
Command Modes
INTERFACE
INTERFACE (BATCH Mode)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
9.7(0.1)
9.7(0.0)
9.5(0.0)
9.2(0.0)
9.0.2.0
8.3.19.0
Description
Introduced on the S-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
Introduced on the C-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
Enter the number of seconds between queries sent out. The
range is from 1 to 18000. The default is 60 seconds.
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
Introduced on the S6000-ON. Maximum range of the Hello
interval value is changed to 18000.
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Internet Group Management Protocol (IGMP) 1132