Mac-Address-Table Static (For Multicast Mac Address) - Dell Z9500 Reference Manual

mac-address-table static (for Multicast MAC Address)

To configure the multicast mode of network load balancing (NLB) on the switch, you must associate a
multicast MAC address with the VLAN used to switch Layer 2 multicast traffic, and add output ports that
will receive multicast streams on the VLAN in the MAC address table.
Syntax
mac-address-table static multicast-mac-address vlan vlan-id
output-range {single-interface | interface-list | interface-
range}
To remove a MAC address, use the no mac-address-table static
multicast-mac-address vlan vlan-id output-range interface
command.
Parameters
multicast-mac-
address
vlan vlan-id
output-range
interface
Defaults Not configured.
Command CONFIGURATION
Modes
Command
The following is a list of the Dell Networking OS version history for this command.
History
Version
9.5(0.0)
9.3(0.0)
Example
mac-address-table static 01:00:5E:01:00:01 vlan 2
(Multicast)
Te 1/2,Te 1/3
Microsoft Network Load Balancing
Enter the 48-bit hexadecimal address in nn:nn:nn:nn:nn:nn
format.
Enter a VLAN ID used to forward L2 multicast MAC traffic to
a server cluster. Valid VLAN IDs are from 1 to 4094.
NOTE: Use this option if you want multicast functionality
in an L2 VLAN without IGMP protocols.
For a multicast MAC address, enter the keyword output-
range then one of the following interfaces for which traffic
is forwarded:
• For a port channel interface, enter the keywords port-
channel then a number. The range is from 1 to 512.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Description
Introduced on the Z9500.
Added support for multicast MAC address on the MXL
platform.
output—range
1169