Dell C9000 Series Reference Manual page 961

ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 00:08:58
Queueing strategy: fifo
Input Statistics:
pkts
Output Statistics:
pkts
Rate info (interval 299 seconds):
rate
line-rate
Time since last interface status change: 00:07:34
Usage Information The Management port is enabled by default (no shutdown). If necessary, use the ip
address command to assign an IP address to the Management port. If two RPMs are
installed in your system, use the show redundancy command to display which RPM is
the Primary RPM.
You can configure two global IPv6 addresses. To view the addresses, use the show
interface managementethernet command. If you try to configure a third IPv6
address, a message displays. If auto-configuration is enabled, all IPv6 addresses on that
management interface are auto-configured. The first IPv6 address that is configured on
the management interface is the primary address. If deleted, it must be re-added; the
secondary address is not promoted.
To view information on a specific PE stack-unit, use the show interface pe pe-id
stack unit unit-number command. You can use the show interfaces peGigE
command to view the information on all the components of the PE Gigabit Ethernet
interface.
To view the show output for multiple ports of a specified slot at a time, you can specify
any random port number or a range of ports, or a combination of both.
To specify a port range, you can enter a hyphenated range of one or more port range
values separated with commas; for example, show interfaces FortyGigE
1/0-4,7,9-11. To enter any random number of ports, you can enter a comma-
separated string of port numbers, for example show interfaces FortyGigE
1/0/1,9,11
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Input 00.00 Mbits/sec,
Output 00.00 Mbits/sec,
NOTE: The port-range option is only available for 1 Gigabit Ethernet, 10-Gigabit
Ethernet, 40-Gigabit Ethernet, Fast Ethernet, FC, Port Channel, and VLAN
interfaces.
0 packets/sec, 0.00% of line-
0 packets/sec, 0.00% of
Interfaces 961