Fip-Snooping Port-Mode Fcf; Fip-Snooping Port-Mode Fcoe-Trusted - Dell C9000 Series Reference Manual

fip-snooping port-mode fcf

Configure the port for bridge-to-FCF links.
C9000 Series
Syntax
fip-snooping port-mode fcf
To disable the bridge-to-FCF link on a port, use the no fip-snooping port-mode
fcf command.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
8.3.19.0
8.3.12.0
Usage Information The maximum number of FCFs supported per FIP snooping-enabled VLAN is twelve.

fip-snooping port-mode fcoe-trusted

Configure the port for bridge-to-bridge links.
C9000 Series
Syntax
fip-snooping port-mode fcoe-trusted
To remove the bridge-to-bridge link configuration from the port, use the no fip-
snooping port-mode fcoe-trusted command.
Description
Introduced on the C9010.
Introduced on the S4820T.
Introduced on the S4810.
NOTE: The fip-snooping port-mode fcf command is not supported on
cascade interfaces or extended ports.
FCoE Transit 859