Ip Ecmp Weighted - Dell C9000 Series Reference Manual

Parameters
maximum-paths
path-fallback
Defaults 16
Command Modes CONFIGURATION
Command History
Version
9.9(0.0)
9.2(1.0)
9.0.0.0
8.3.10.0
Usage Information You must save the new ECMP settings to the startup-config (write-mem) then reload
the system for the new settings to take effect.
Related show ip cam linecard
Commands ports on a line card.

ip ecmp weighted

Enables weighted ECMP calculations.
C9000 Series
Syntax
ip ecmp weighted
To disable weighted ECMP calculations, enter the no ip ecmp weighted command.
Defaults N/A
Command Modes CONFIGURATION
Command History
Version
9.9(0.0)
9.7(0.0)
Usage Information Enabling this CLI would inform the FIB to re-program the destination prefix paths with
weights in the HW/CAM on the fly.
Specify the maximum number of ECMP for a route. The range is
2 to 64.
Use the keywords path-fallback to enable this feature. If you
enable the feature, re-enter this keyword to disable the feature.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the Z9000.
Introduced on the S4810.
– Display content-addressable memory (CAM) entries for a set of
Description
Introduced on the C9010.
Introduced on the S-Series.
Equal Cost Multi-Path (ECMP) 846